ISO 4141-3-2019 pdf download.Road vehicles一Multi-core connecting cables一 Part 3: Construction, dimensions and marking of unscreened sheathed low-voltage cables. 3 Terms and definitions No terms and definitions are listed In this document. ISO and IF.C maintain Lerminological databases for use In standardization at the following addresses: — IEC Electropedia: available at httpJ/www.e1ectrupedia.or/ — ISO Online browsing platform: available at https://www.iso.org/obp 4 General Requirements Multi’corc sheathed connecting cables for basic performance according to this document shall comply with the requirements of ISO 4141-I. Multi-core sheathed connecting cables for high performance according to this document shall comply with the requirements of ISO 4141-2. S Construction and dimensions 5.1 Single cores S.L1 General During construction of the cable, the positions of the single cores within the cable construction shall be laid up. as far as possible, in accordance with the contact ositions of the connector as specified in ISO 1185, ISO 1724, ISO 3731, ISO 3732, ISO 7638-1, ISO 7638-2, ISO 11446-1, ISO 11446-2, ISO 12098 or ISO 25981 as applicable. NOTE AnnczA provides a synopsis of the nominal crass-sections *1 single cases in multi-core cables specified In the International Standards cited above. 5.1.2 Additional elements Fillers may be used to complete the cable construction. Non-metallic tapes or wrappings under the sheath or an Inner sheath may be applied. 5.2 Outer sheath dimensions S.2.1 Thickness The minimum thickness of the sheath, measured in accordance with ISO 4141-1, shall be 1 mm. 5.2.2 Outside diameter The outside diameter of the multi-core cable, measured in accordance with ISO 4141-1, shall be as specified in Table 1. The cable ovality, measured in accordance with ISO 4141-1. shall not exceed 10%.ISO 4141-3 pdf download.
Download Address
Download