ISO 10320-2019 pdf download

ISO 10320-2019 pdf download.Geosynthetics一Identification on site. The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. ISO 10318-1, Geosynthetics — Part 1: Terms and definitions ISO 10318-2, Geosynthetics — Part 2: Symbols and pictograms 3 Terms and definitions For the purposes of this document, the following terms and definitions apply. ISO and IEC maintain terminological databases for use in standardization at the following addresses: — ISO Online browsing platform: available at httpsJJwww.iso.orgJobp — I EC Electroped ia: available at http://www.electroped iilMrg/ 3.1 supplier person or organization from which a geosynthetic is purchased or otherwise obtained Note I to entry: A supplier who is not the manufacturer is expected to ensure that the responsibilities of the manufacturer are fully met. 3.2 product name brand name name given to a particular product or complete range o products 3.3 product type descriptive number or code given to a particular material produced to a particular specification 3.4 unit identification information, e.g. number or other code usually given on each unit (e.g. roll) during or after production, which allows the original manufacturer to trace at a later stage the production details, including place and date of production.4 Identification 4.1 Unique identification on delivery For the purposes of positively identifying the product at the time of delivery to the purchaser. geosynthetics shall be supplied with the following information affixed (e.g. label) to each unit: a) manufacturer and/or supplier; b) product name; c) product type; d) unit identification; e) nominal gross mass of unit, in kilograms; 1) unit dimensions (of material, not of package); — roll goods: length x width (both in metres), — other goods: number of items (e.g. sheets or fabricated bags or tubes) x length x width (both in metres), or area covered by the product; g) product classification using terms and symbols defined in ISO 10318-1 and 150 10318-2; h) main raw material type(s) performing the function (for each component); I) colour identification unique to the product name and type (only for products identified by colour marking). 4.2 Product marking for identification on installation There shall be a means 0 positively identilying the product at the time of its installation, even ii it is no longer...