ISO 21111-4-2020 pdf download

ISO 21111-4-2020 pdf download.Road vehicles – In-vehicle Ethernet一 Part 4: General requirements and test methods of optical gigabit Ethernet components. This document specifies the optical components requirements and test methods for optical gigabit transmission of in-vehicle Ethernet. Safety (electrical safety, protection, fire, etc.) and electromagnetic compatibility (EMC) requirements are outside the scope of this document. 2 Normative references The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. ISO/I EC/ IEEE 8802-3:201 7/Amd 9:2018, Physical Layer Specifications and Management Parameters for 1000 Mb/s Operation over Plastic Optical Fibre ISO 8092-2, Road vehicles — Connections for on-board electrical wiring harnesses — Part 2: Definitions, test methods and general performance requirements ISO 8092-3, Road vehicles — Connections for on-board electrical wiring harnesses — Part 3: Tabs for multi- pole connections — Dimensions and specific requirements ISO 16750-1, Road vehicles — Environmental conditions and testing for electrical and electronic equipment — Part 1: General ISO 16750-3:20 12, Road vehicles — Environmental conditions and testing for electrical and electronic equipment — Part 3: Mechanical loads ISO 16750-4:2010, Road vehicles — Environmental conditions and testing for electrical and electronic equipment — Part 4: Climatic loads ISO 16750-5, Road vehicles — Environmental conditions and testing for electrical and electronic equipment — Part 5: Chemical loads ISO 2111 1-1, Road vehicles — In-vehicle Ethernet —General information and definitions IEC 60068-2-60, Environmental testing — Part 2: Tests — Test Ke: Flowing mixed gas corrosion test IEC 60793-1-20, Opticalfibres — Part 1-20: Measurement methods and test procedures — Fibre geometry IEC 60793-1-2 1. Opticalfibres — Part 1-21: Measurement methods and test procedures — Coating geometry IEC 60793-1-40, Opticalfibres — Part 1-40: Attenuation measurement methods IEC 60793-2-40, Optical fibres — Part 2-40: Product specifications — Sectional specification for category A4 multimode fibres IEC 60793-1-43, Optical fibres — Part 1-43: Measurement methods and test procedures — Numerical aperture measurement.ISO 21111-4 pdf download.