ISO 23223-2021 pdf download.Alpine ski boots with improved walking soles一Interface with alpine ski-bindings – Requirements and test methods. 4.3.8 Mounting point The mounting point for positioning the binding on the ski shall be indicated by a line on each side of the lower surface of the boot as close as possible to the ski. This line shall be clearly visible and permanent. It shall not be less than 10 mm in length and shall not be more than — TypeA:5 mm,or — TypeC:4rnm from the middle of the boot sole length. The deviation between left and right boot shall not be more than 1 mm. 4.3.9 Sole length lithe sole length that is defined in Figure 1 (Type A) and Figure 3 (Type C) is marked on the boot, such marking shall be within a tolerance of ±2,5 mm. 5 Marking Ski-boots shall be marked at least as follows: a) Replaceable soles shall be marked with reference to this document (i.e. Iso 23223:2021), at least 3 mm high. Markings shall be placed on each replaceable sole component. A specific technology logo or pictogram or colour code can be added. b) Letter symbol A or C for Type of boot on the shell beside the mounting point, at least 5 mm high. The letter shall be permanent and easily recognizable. c) Name or trade-mark of the manufacturer or importer. d) The boot shall be marked with reference to this document on a clearly visible area from the top on the boot shell, between tip and midsole mark. A specific technology logo or pictogram or colour code can be added. The total marking size should be at least 8 mm. NOTE For marking the binding see ISO 9462 and ISO 13992 and for boot-binding compatibility see ISO 11088 and ISO 13993. 6 Information supplied by the manufacturer 6.1 General An easily comprehensive information supplied by the manufacturer shall be enclosed to each pair ot ski boots. It shall help a non-qualified user to operate, handle and maintain the boots.ISO 23223 pdf download.
Download Address
Download